Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

ewx14440w washer dryer door lock wiring?

I have replaced the door lock but since the electrical connector was damaged I cut this off and used female spades. Sadly I dropped the cables and now cant figure out which one goes where - should have marked them first. I have traced them back to the PCB - there are two on a red connector and two on a black connector. The door lock end is marked 2345. So which wires go to which?
Ian, March 2013
That's why I said make note where they come from!
now you are in stuck.Serviceforce are main agents for these so if you approach them they might show you circuit diagram on PC screen OR you could just buy a new wiring loom and plug it in both ends

CK, March 2013