I have a mk 2 carver cascade water heater and I am looking for the 5 amp fuse for it.
It states in the manual I have that there is one but not where it is I have had the control panel off and it is not behind that.
I have looked at all my fuses in the zig 4000 charger and they look all ok I seem to have seen it on some forum saying it is situated at the rear of the burner module. thank you.

ron, March 2013

http://www.swift-owners-club.com/support/oem_handbooks/carver/cascade_mk2.html

Caratech, April 2013

If you have the older type with gas control on front of the seat near water heater if you pop out the two screw caps remove the front (back inside seat base is just a patress box and will drop when you remove both screws.

Look at the back of the cover and all controls and wires will be there and there may be two clear glass fuses, one I think is a spare. Remove each look for one with burnt wire(blown) and if other is a spare replace the blown one and keep it to show to get a replacement fuse so you always have a spare.
hope this helps.

bob, March 2013