Andrew - C asked ... Stannah 400?    |    Liam asked ... Belts for old WEBB Mower?    |    Leith asked ... Bosch Classix Type WKM41 front loader washing machine?    |    Pam asked ... Do I need to open the housing to dry the motor?    |    James asked ... Remove enterprise enrolment from an Asus Chromebook C523N?    |    Click here to ask your question

hotpoint 1st edition washer/dryer brushes sparking?

sparking from brushes causing brush carriers to melt & brushes to stick in carriers.I've cleaned the motor armature as previously suggested but still faulty.motor seems to run ok ,is there some sort of spark quench anywhere.
mike jones, November 2006
the fault was due to a partial blockage in the drain causing water to stay in the drum too long and putting extra strain on the motor.

mike jones, October 2007
i would suggest give it a good clean but also there are two types of brush for these,cheap and proper, go for the proper ones they should be white not black, also if the drum bearings are going the motor has to work a lot harder this can make it overheat check the drum for up and down movement

phil grimshaw, November 2006
You never mentioned if the brushes were new, if not try new brushes as they will cause problems when they look only half worn. Also, after cleaning the armature, make sure you clean out all the debris.

2512steve, November 2006
link Click here to see other fixes for Hotpoint.