GG asked ... Fix food processor motor?    |    T asked ... How do I turn the delay off on Electrolux DX302 dishwasher?    |    Helen asked ... How can I mend my Kenwood Gourmet FP505?    |    Roy Turner asked ... Kohlangaz Gosford HE fire?    |    Peter asked ... How can I mend a Powerwasher PRO PRO1800PWE?    |    Click here to ask your question

home Fix label Security Systems label_important Home Alarm Systems category Scantronic

scantronic ic8 chip required?

9600 chip required.
Anyone?.
Paul Parsons, November 2013
home Fix label Security Systems label_important Home Alarm Systems category Scantronicdone
mr parsons if you had better manners you would have had the chip free of charge from gts any way and its a hard chip to obtain these days ,but I have 4 of them in stock,so good luck in your search ,maby you have better manners in future

gts, November 2013
I bow to Frankenstein ,facing forward of course :-)

gts, November 2013
true alarm guy,your the voltage master :-) anyone who licks a battery is nuts,like the guys who kicks a car tyre and says car is good is nuts ,one born every minute :-)

gts, November 2013
You`re so funny guys,
There are about 5 deaths a year from people ;icking a 9Volt cell.

Fools, ONLY I CAN SURVIVE THAT muwhahahahaha

Alarm, November 2013
Lol, the voltage increases as you get older "frankie",
I'm at that age now where I need several 24v jolts every morning to kickstart me into life. :D

e manno, November 2013
your nuts ha ha ha!!!!!! you do anything for a few volts in your gub !bet you suck on a 9 volt battery for fun !

gts, November 2013
Used to pull them with a terminal and my Earth bonding was my tongue wrapped around the casing.

I AM FRANKENSTEIN :P

Alarm, November 2013
have 3 or 4 e manno,but not for this guy,his ignorance has cost him,with me anyway

gts, November 2013
Hey I had one for him but I bent a pin pulling it from the board. :D
Maybe if he had manners then he would get a better result.

e manno, November 2013
alarm guy,e manno,do we have an engineer on here called anyone ? don't think so,mabey manners get a better result !

gts, November 2013
Not use the correct removal tool

Alarm, November 2013
Easily damaged them nvm's.
Bend the pins did we?.

e manno, November 2013
link Click here to see other fixes for Scantronic 9600.

Fix Fault - Security Systems

home label Security Systems label_important Home Alarm Systems

How to turn of tamper alarm on Logic Six house alarm?

Security Systems > Home Alarm Systems

I have a problem with my house alarm system SYSTEM: EUROSEC?

Security Systems > Home Alarm Systems > EuroSec

Thorn tc3800 house alarm?

Security Systems > Home Alarm Systems > Thorn

Tamper won't go off?

Security Systems > Home Alarm Systems > Scantronic

Concept 6?

Security Systems > Home Alarm Systems

Trying to change battery on door connect?

Security Systems > Home Alarm Systems

Factory reset?

Security Systems > Home Alarm Systems > Paragon

How can I reset a Scantronic 9427?

Security Systems > Home Alarm Systems > Scantronic

Fix Fault - Security Systems

home label Security Systems label_important Home Alarm Systems

fixfault.com

fixfault.com for free repair help, information and advice.

How can I fix my Thorn TC3800?
How can I fix my Accentra G4?
How can I fix my Risco Gardtec 800?
How can I fix my Micromark MM9495B?
How can I fix my Veritas 8?