Hi
It's me again! I have a new problem now and I was wondering if you could help seen as you did last time.
When I set my alarm, the pir sensors in the rooms do pick you up so I know they are working. However, once the alarm has set, if I walk into a room the alarm does not go off until about 1hr 15 min later!! When it does eventually set off, it turns straight off when I key in my code and does show the correct room that I did go in earlier. The tamper light shows on the keyboard though. Any ideas!

Alex, December 2013

good for you e manno,you got a thank you

gts, December 2013

Cool thnx for getting back to us :)

e manno, December 2013

Hi
I tried what you said and it worked!!!! Thank you ever so much!! I really appreciate your help again.
Alex

Alex, December 2013

IIRC the plus and G3 models have a programmable bell delay of up to 99 mins.

So if you have accidentally pressed the wrong buttons whilst in engineering??.


Just a thought :)

e manno, December 2013

Haha! Thanks very much for your advice. I will try that and get back to you :) :)
Alex

Alex, December 2013

We like our scantronic's Alex :)

Worth going into engineering and check the bell delay timer.

It's feature is mainly used on monitored systems.

See, bell delay active means no bells so the boys in blue respond and catch intruder in the act.Yeh right ... charge of the light brigade and heard a mile away.

Lazy feckers.

Worth checking it's easily done,

So once in engineering press 7 then 2 for bell delay then enter 00 that turns bell delay off then press reset twice.

e manno, December 2013

not being rude mate invest in a scantronic 9651 you wont go wrong

gts, December 2013

Oh ok thanks!

Alex, December 2013

yes get rid of that panel its rubbish

gts, December 2013