Our Creda washer (1000 Economy Plus) is going through cycles without spinning. There are blue sparks flying off the brushes when the machine is running. Brushes were recently replaced by the previous owner, but perhaps they aren't installed properly or did they just wear out quick? Question: How do we access the brushes for removal? We're in California where Creda repair-people are non-existent. If it's true that the stock brushes wear out too fast, is there a substitute we can order to replace these? Please help!

Elaine, January 2005

Creda CWA 242 (1706E) Eco 1000 series

No need to remove motor to replace brushes.

Brushes should be Part number 1600474 (GE hotpoint), install according with service bulletin.
1. remove brushes - "retaining latch on brush"
2. clean communicator -all carbon needs to be removed
3. Release brushes
4. install brushes
5. break in - 2 complete fast cycles.

There is only one place I am aware of to get Creda parts in North America

Creda Service Center
15545 North 77th Street
Scottsdale, AZ 85260
800-800-2733

Mike - Buffalo NY, January 2005