Hi there,

I was re-connecting the boot switch to a Nissan Micra but I somehow managed to break one of the pins on the connector on the loom side. I was just wondering, is it possible to get a replacement connector and attach it to the loom. The connector would be a 2-pin female connector (basically the opposite end of the connector that is shown http://www.3dlabellingsystems.com/Images/Nissan%20Micra%20Boot%20Switch%20Fault/Nissan_Micra_Boot_switch_Rear_view.gif)

I spoke with the Nissan dealer and they said that the only solution might be to solder the switch directly to the loom but I'd like to avoid this if possible.

Thanks

Niall, January 2014