andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

how to fit rear brake pads to an iveco daily 35S12 ,2005 model?

As above but the problem is that the piston will not comptess back to allow fit of new pads ,is it to do with the hand brake assembly do i have to do something with that to allow the pistons to move back.
Ian Thompson, March 2014
I am not sure but these used to have a separate h/brake system with small shoes acting on an inner face of the disc and the brake pads/foot brake was a separate system altogether,but if the h/brake us incorporated onto the brake pads then the pistons will need to be wound in,some models were r/h wind on the offside and l/h wind on the near side so would check that out,also a wind back tool would be required,good luck

cdc, March 2014
link Click here to see other fixes for Iveco 35S12.