Lou asked ... Mac Allister 35cm electric lawn mower?    |    Ronald Charlwood asked ... Beko fridge/freezer not cold enough?    |    John Broadbent asked ... Advise?    |    suzy asked ... Brother kh-940 not in sync with DAK9 in interactive knitting?    |    Susan asked ... How can I stop my steam iron spraying water with the steam?    |    Click here to ask your question

reich kama mixer tap?

Need to remove the whole tap but has bend in red and blue feed pipes so can't access nuts. How do we remove
clare, July 2014
First go to caravan shop explain what you are doing then they can supply parts needed and a better way of removing the pipes

my experience is to have to cut the pipes away from the taps or if you can access the clips holding the pipes to taps slacken right off and heat up pipe ends with hair dryer twist and yank the pipes off the tap then access the nuts or usual splitting the pipe on the tap fitting after sliding clip out of the way will be sufficient to work the pipes off then cut off the split bit on each. if not enough slack to re fit pipes get pipe joiners and length of pipe one colour ,say red and bit used for cold put blue tape on it.

bob UK, July 2014