wire came loose off of motor

roy, September 2014

Sorry Roy - I had just looked at a Lawnmower question and missed this as being about a Vacuum Cleaner.

Forget my references to a kill switch - what a fool I am...

But the first part still stands - the length of the wire and a terminal with no wire attached are good clues to where to fix it.

A circuit diagram will be a technical drawing - component layout and very probably not isometric.

Horror Vacui, September 2014

Then put the wire back where it came from...

The length of the wire will give you a clue

A terminal point with no wire on it will give you a clue

My guess is that it's the kill switch wire which usually connects to the machine's frame - but that's just a wild guess.

You might trace the wire back to where it comes from - if it connects to the kill switch than just fasten the loose end to the chassis - anywhere will do.

Good luck...

A Ground, September 2014