The instructions say to remove filters from the supply connection and clean out. There is a pink coloured filter connected to the dishwasher end of the supply hose but I can't remove it to clean it. Any ideas ?

Steve, March 2015

Hi Kenjo, I have installed the new part as per your instructions, reconnected and turned on. All was running well for 13 minutes until the 'check water' light came back on. Aaargh. Do you know of any other solutions ?

Steve, May 2015

Thanks sorry late reply, your flow meter is called an 'impeller jug' part no 00424099, it is situated in the hose that runs from the inlet valve to the plastic side water jacket. To access it unplug from mains, remove worktop, remove left hand side panel remove hose from it that joins water jacket, remove small square panel that holds the inlet valve, disconnect wires to valve then pull valve out with impeller jug attached, replace impeller jug, refit all you undid, have a beer, job done. cheers

Kenjo, April 2015

Hi, I think this is the model nr SGS46E28GB

Steve, April 2015

Most likely problem is the flow meter in the machine is jammed need model no to advise where it is

Kenjo, March 2015