how do I get the engine cover off the flymo glidemaster (340 in my case) I have undone all the screws but cannot see how to remove the cover - it still seems to be clipped in
I saw the same question raised before but the answer is not visible

Lawrence Gray, April 2015

I have one of these - and have just looked at it.

There seem to be 2 screws on the top and three screws underneath - two of them at the bottom of deep channels - perhaps 4 1/2" down - so you'll need a long bladed cross point driver. Just turn it on its side and you'll see the screws - a torch might help.

Good luck..., April 2015