Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    Click here to ask your question

My hot point FDW70 has error A10 showing?

The machine will begin any programme cycle and the drain pump will fire up as usual straight away. However exactly 2 mins into each try the machine beeps and Shows A10 fault.
I have stripped it down and used a multi meter on the flow heater which was fine, the water inlet valve which was fine and the pressure switch which I think was ok but was a 3 way connector. After reading forums it pointed the the PCB, just put a new one on and same damn fault A10!!! Someone please help, thankyou
Dean Hill, August 2015