andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

How do I change a PCBA receiver in a dimplex opti flame fire?

The Dimple fire works and provides heat but the flame effect dosnt. I have purchased the PCBA receiver but not sure of the correct procedure to change it
Russell Johnson, December 2015
Is the fire an X1 or an Exbury if so remove the grate then the glass by removing the 2 quadrant beads (there are 3 screws at the back each side you will then see the pcb

toptrish, December 2015
link Click here to see other fixes for Dimplex Opti-Flame.