Hello
After removing wheel there is no access to bearing hub as it is set back into the surrounding casting. No bolt holes for fixing pulling tools .
How do I access the bearings.
Was hoping it was the old system when you pop off the domed cover to access the castle nut / split pin and remove.
Looking like have to have the whole unit removed with special tools?

Wunderstuff, February 2017

Thanks CDC.
I was hoping that was the way.
L D V. Love them.
The manufacturers got many things wrong but so many other things right.

Wunderstuff, February 2017

Used to use a long tyre lever to remove hub cap, some are tight but they usually move,split pin and 15/16" nut, tapered roller bearings and there are notches in hub to knock out each bearing race, good luck.

cdc, February 2017