Peter asked ... How can I mend a Powerwasher PRO PRO1800PWE?    |    Mike asked ... Bosch WTA74200GB Vented Dryer?    |    Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Click here to ask your question

how we can we reset without the code?

We have a c and k securitech alarm system ST800L+ which we have never used as we moved in 4 years ago and didn't have a code. For some reason it went off last night at 2.45 and we had to wait till it shut down after 30 mins. Worried it might happen again. How we can we deactivate or get another code? It was installed in '02.
D.Sanderson, February 2020
As with most alarms, ignore the key pad and locate the main contol box. Disconnect this main control box from the mains power and then open it up to reveal the large batteries inside. Pull the connectors off the battery terminals and this will deactivate the system permanently. During this process, the tamper alarm will probably sound and should eventually silence once the additional backup batteries in the outside alarm sounder run out of power. To speed up the process and kill the alarm sounder sooner, put some ear plugs in, grab a ladder and open up the outside sounder and disconnect any batteries you find in there.

Rupert, February 2020