I have exactly the same problem as you. The drier actually does everything apart from heat up.
I also checked out both of the rear thermal switches. The 'Red' one was open circuit the 'Blue' one was closed circuit. I then made up a little jumper lead using a legth of suitable wire and two male spade crimps. I removed the Red thermal switch and used this 'test' jumper wire as a substitute for the RED thermal switch. I then switched on the drier with this jumper lead in place and Bingo ! the heating element heated up straight away. Please note though this wiring arrangement was just for very short testing purposes, i noted that the heating element started to glow dull red after only 2 or 3 seconds , so i was ready with my hand on the wall switch to turn off almost immediately !
Are these switches a High Heat one and a Low heat one ?
The one mentioned at the front of the machine being an overheat switch ?
I just need to find somewhere to buy one, The Numbers printed on the side of it are 36fxe14 20102 L103C SO303 . I presume these are different part numbers for different Drier manufacturers, rather than a single very long part number ?
[B]Where can i buy one from ? [/B]
SAFETY NOTE:
I am an Aircarft Electrical Engineer by trade and so used to working with, and testing, exposed live High voltage electrical circuits. If anybody is not able or confident working with potentially lethal voltages then please leave this to a domestic appliance repair man. Make sure all kids and pets are clear of the area too , little fingers and wet noses don't mix with electricity.
Tim from St Andrews, January 2005
