My ideal icos is only two years old and for some reason it just wont run. ita a conventional boiler on a pressurised system. there is power to the boiler and the system is pressurised to just over 1bar, all controls call for heat, the room stat is calling for heat but it wont fire. the control panel, according to the book, should show a fault code but it wont even show that. thers no lights no nothing on the panel. the power switch is fine and lights up when switched. the pumps not jamed and its got power. i think that the board has gone due to having no display at the front panel. nothing hapens when i press the reset button its just if the boiler is dead apart from the on off switch. ive only been in this house a couple of weeks and have noticed the reset buton shows signs of wear. this was from most probably the previous owner. any idears, thanks in anticipation.

dave, March 2007

Hi, call british gas out to replace the pcb ( if thats what it is) you will pay a fixed fee and if will probably be far less than the cost of the part!!

Paul the gas man, March 2007