Hi,

My simpson aquarius doesn't know when the tub is full of water. Someone told me it's the pressure switch is bung. Anyone know where that is?

Daniel Beattie, January 2005

Hi Lindsay,

Thanks for your advice. I had a look at the hose going from the water level switch into some kind of connector (the diaphragm isn't accessible from the top); it was on but not very tight, so I replaced it with a vacuum hose I had left over from my car. It's the same internal diameter (almost) but the outer thickness is different; will this matter? Do you know what this hose actually carries?

Thanks again for your help.

Daniel Beattie, February 2005

hi, on the left hand side of the control panel the water level "switch" connects via rubber hose to a diaphram. i would take the top panel off first and make sure hose is OK and connected OK. I am not sure if the diaphrapm is accessed from the top

lindsay, February 2005