machine fills and washes and empties but will not spin dry belt is in place and beleive motor to be ok

paul, May 2007

reduced time stopped working

mike, September 2011

my machine still washes and spins but is leaking i think its the pump...does this sound right? is a new pump easy to fit?

tracy g, February 2010

I have a Bosch Classixx 1000, it's approx 4 years old. I can hear the spin motion, but the drum is not spinning, would this be the belt? Or carbon brushes? Haven't called out an engineer as yet, as was wondering whether it could be a DIY repair job?

Sharon, August 2009

how do I replace the boot gasket

Sam, May 2009

my machine is not draining properly, after a spin clothes still soaking and water in bottom of drum. What do i need to do?

mbarnett, January 2009

Just replaced the brushes on mine.

You can just about get away with not removing the whole motor - if you know where to look and have small fingers.

Quite an easy repair in the end...and it solved the problem of course!

Richard, July 2008

I have a bosch classixx spin dryer which is around 5 years plus been fine until this week. When you switche on the dryer it wont spin, what could be the problem. Is it worth repairing or getting a new one

stephen costello, June 2008

I have exactly the same model Classixx 1000, and last week had the very same thing. It turned out to be the brushes needed replacing as they were worn out. I had feared it being something terminal, so I called out an engr, but he had the job done in less than 40 mins, and that was including a mug of tea.
I've changed brushes on previous machines and this was just as straightforward,coz I watched him and couldn't believe how simple it was. Disconnect power/drain hose and tip machine on its side. He removed the belt then unbolted the motor (just a couple of nuts/bolts and the brushes were the old-fashioned type). Good Luck!!

Tim, May 2007