number 1 and 4 leds flash off about every 5 seconds and door lock led flashes constantly.power switch works,but machine refuses to work on any selection made.This problem started after a power cut

Roger Moxham, May 2007

hi that lots a load of rubbish im afraid here are the fault codes for the machine

widl codes - light flashing from left to right are numbers 1-4

f01 light 4, motor triac
f02 light 3 motor, jammed/ tacho
f03 lights 3&4 Ntc fault
f04 light 2. pressure sw stuck on empty
f05 lights 2&4, pressure sw stuck on full
f06 lights 2&3, N/A?
f07 lights 2&3&4 heater relay
f08 light 1. heater relay
f09 lights 1&4 eprom/setup error
f10 lights 1&3, pressure switch not sensing
f11 lights 1&3&4, pump/draining error
f12 lights 1&2, communication error
f13 lights 1&2&4, dryer ntc/ fan motor
f14 lights 1&2&3, dryer heater
f15 lights 1&2&3&4, dryer heater relay
f16 N/A
f17 light 4, door lock
f18 light 3 comms error (3 phase motor) power board

f1 and f17 share the same light
Anymore questions or parts required http://www.freewebs.com/msdapudsey1
Just go to the forum

phil grimshaw, May 2007

you need to reset machine back to begining of wash program that it was on when had power cut .failing that phone electric board thier foult!!!

dave, May 2007

have u tried unplugging leads out ov program inside washer /at back on left hand side? .if not unplug and turn washer on and of and plug back in!

dave, May 2007