how do i change the belt on my tumble dryer? its a creda reversair model number 37377. I think it is the belt that has gone but not sure, the heat is still there but the drum does not go round but when I have taken the back off the fan at the back is still moving. I am unsure how to get to the inside of the dryer because when I have taken the back off there is another panel which I cannot remove. Please help Marina

marina, June 2007

I have a similar model (TVR2)- I hope my comments help. It is not hard, but very messy (ie a bad design)! You have to take the front and side panels off, so that you can slip the new belt over the drum and then over the drive shaft of the motor. Easy, but lots of screws and lots of patience putting it all back together. The belt will have left a mark on the drum, so its fairly easy to see where to place it. Good luck!

Richard, June 2007