Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

mac 338 what are the standard mixture settings?

Hi have a mac 338 that wont start, a friend??? messed around with the high/low settings, would like to know if there is a standard number of turns/screws i can set to start it?
Phil, June 2007
your machine will run at a turn and a half out but getting it to run properley is a diff matter when you get it right it will throttle up and down with no pause or delay

madpoppydog, April 2010
a 40:1 ratio of 2 stroke to unleaded 0.125 litre to 5 litres unleaded

steve, December 2007
You should ask the dealer or a different friend however bringing them out to 1 1\2 each shouldn't get you into too much trouble. R

RB, July 2007