I have recently just added on 2 additional zones into my existing system but they seem to have been omitted by the engineer at installation.
Does anyone know how to put these zones back on so when alarm is set these are part of the detection system

Derek, July 2007

when i set the alarm and omit a zone should should the light show that particular zone

john slater, December 2014

Hi Derek, Assuming the engineer code is default 9 9 9 9 do the following to set your zones to "security" mode.

press "Prog"
enter 9 9 9 9 (engineer code)
press 5 (zone configuration)
Press the number of the zone you want to activate.
Press 1 ( security mode for that zone)note, zero turns it off.
Press reset 3 times
Check the zone works with walk test, if all is well program in your next zone in the same way.

Good luck !
If you get any problems, post as a reply here, I will monitor for a couple of days.
You may want to check the backup battery while you are working with the system, if it is over 3 years old you should replace it, as a faulty battery could damage the main PCB, not to mention the aggro from false alarms if you get mains failures.

Pete, July 2007