since we have had the floods my alarm has been stuck on zone 8. when i try to put my code in or press any other button i get a funny bleep but nothing seems to happen. the bell box works as i have tried the emergency button and that is fine. any suggestions

alina, July 2007

if you open the pannel and put a link in across zone 8 terminals this should the put zone 8 indicator light off. if it does you have a cable fault to whatever zone 8 is. If the light is still on with the link in then it will be a pcb fault.

Rob, July 2007

1st findout whatzone 8 is, then where is zone 8, does it include a siren box outside. figure this out and we will go from there
also figure out where alarm is plugged in, unplug it, unplug battery inside the can, wait ten minutes, plug in battery 1st, then plug the transformer in. did you have electrical damages to the house, you may need a new panel

mickey, July 2007