The program is erratic, when started at 4, it either sticks there or steps around the programs and just stops anywhere. I can empty the machine ok and put it on a spin cycle. I have checked the pump and hoses and all appears clean. Any ideas?

clive Richardson, March 2005

No electrics cut out at spur fuse - is this a door catch fault as it is a little difficult to close a times - is there a electric sensor on the door at fault

Nick, April 2012

The door catch sticks and is a little difficult to close resulting in the fuse at the spur to blow is this the cause

Nick, April 2012

Sounds like the front panel programmer is faulty, probably a worn internal gearing or intermittent drive motor. I assume that you have checked and make sure that each action works (drain pump, motor wash action, motor spin action, fill, etc )by driving the programmer by hand to the relevant positions. If these functions work its unlikely to be a problem on the main control PCB.

garryk, February 2007

Is it filling with water?

Paul - www.washwise.co.uk, March 2005