Kenmore 80 series
Recently my dryer stopped producing any heat. It still tumbles, etc, but there is no heat. I have tried different 'temperature' settings (permanent press, cotton, etc). It is usually set to cotton.

thanks

mike s, March 2005

Very helpful. Thanks.

Andy, October 2012

take off the piece with the heater.then go to a appliance place test the heater core.if its good its more than likely the thermastate.i got mine for 49 bucks with tax.it was not hard to fix at all.good luck.mine was the 110 model.

cal, October 2011

I have a kenmore dryer 80 series and it is 7yrs old. It doesn't not tumble, I have heat but the drum wont move.

karen, July 2005

Well, There doesn't seem to be much help here... I will go ahead nd answer my own question for future users:
The Thermal Cut off was bad. It's located on the Heating duct and when you replace it, it should be replaced with the Hi Limit Thermaostat. They come as a kit (part #: 279769). I guess most of these are accesable from the back through a panal, mine was through the fromt kick plate. I had to take a couple screws out of the supportting leg, but then, with a couple gentle twists, it came out. I then had to dissconnect one of the wires to the heating coil in order to get it out far enough to work on. You should check the heating coil with an ohm meter (should have resistance, if not it's bad). I found several of these kits online, but I got mine from a used appliance place for $15.

mike, March 2005