firstly remove the plastic cover that runs along the rear of the engine bay, then there should be three bolts holding the wiper assembly in place, 1 to the left behind the steerring wheel,1 in the centre and 1 just below the motor. when you have taken these out then disconnect the block connecter from the motor and you should be able to remove the whole lot quite easily.then just swap the motor over to the new linkage though be carefull to take note of the position of the arm that runs of the motor to the linkage as this will determine were ur wipers start and stop.also before you do anything make sure the motor is in the finishing position.
gav, September 2007
