andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

Temp reading on Hotpoint Minstral FF93N?

The display temperature for the freezer shows readings in excess of +30 degrees C even though the cabinet is at normal temp. Then later shows -22 degrees C as expected. Later still will show incorrect high temps again. Is it a simple part replacement???
Robert, October 2007
Thank you BG for your response.After I posted the question the freezer started to frost up, so I replaced the freezer thermister (green) and solved the problem.

Robert, October 2007
Sounds like a board fault otherwise if the temp read high correctly, the alarm would go off.Control pcb's around £50.00 and are in the top plinth,couple of scres ither side underneath and the plinth pulls forward.
Always unplug before dismantling.

BG, October 2007
link Click here to see other fixes for Hotpoint FF93N.