My Neptune doesn't spin out all the way especially if it has a full load or a small load. Can I repair this myself or do I need a service call?

Beckie Sullivan, April 2005

My Maytag washer will not pump out water after the wash or rinse cycle.

Joe Silva, March 2007

more for anyone w/this and other issues on Maytag Neptunes

http://www.applianceaid.com/neptune.html
http://appliancehelp.hypermart.net/xmb_neptune_mah3000.pdf

MARK, May 2005

My mistake.
It is appliance411.com.Sorry

mark, May 2005

BE SURE MACHINE IS UNPLUGGED B4 DOING ANYTHING!!!

Check the balance sensor.This is in front of the washer and requires removing the door and two screws on opposite side of door.The front will now come off.Look for two large blue wires going to sensor and make sure these are clipped on tight.While you are at it reset sensor by pressing button on bottom of sensor.Sensor is very obvious as it is bright white against black framing of machine.To test:plug machine in,press door lock sensor in & turn control dial to spin.Press on/off button.
If you're lucky it will just be a loose wire or reset.
In the future don't overload machine.
If this isn't the answer try appliance911.com
Good luck & SAFETY FIRST AROUND ELECTRICAL APPLIANCES!

MARK, May 2005