the fault code is either 5P or sp on the display.
the load stops spinning and when open, it was all piled up on one side but the machine is leveled properly

Louis, April 2005

Check for broken wires near where the wiring harness leaves the cabinet and crosses over to the bowl. Repair if broken (very common with thin wires)

grub, October 2011

My EZI 905 is driving me crazy because if the out of balance problem, since setting the eco rinse button to ON I don't seem to have any problems???? If you have this setting could be worth a try.

Trish, June 2007

im unsure of the error code but since your symptons with clothes thrown to one side may indicate the following:

if you know how to press the door latch switch on with lid open/removed proceed doing this: when the machine goes into spin cycle look at the agitator and bowl to see if both are spinning (both will be at the same speed). If the agitator is spinning only and throwing the clothes to one side you have a fault with the brake solinoid this is the device that releases the brake and allows the bowl to spin freely in spin cycle.

if this is the case please message back for instruction for removal and fitting

then the solinoid fails this will cause a out of balance

brad, April 2005