How do I fix my Hotpoint wm22?

The machine does not drain properly after a wash the clothes are still very wet. I've checked the pipes which are not kinked. Is there an internal filter ?

done

how to fix a lock and seal on hotpoint aquarius 1100 wm63?

when ive shut the door on the washing machine and set programme the door does not look and the washing machine dont work.

done

Hotpoint Wm62 Overfills?

This machine hasn't been used for a few months, but was working ok. Now I select a cycle, the drum begins to fill....and doesn't stop. Till the point the water started to come out of the washing po ... more

done

help needed for my hotpoint aquarius 1200 deluxe?

help please put a notice up yesterday my door was stuck( i over loaded my machine) i have now got the door open but now the machine wont wash or spin help

done

I have an error code F03 on a Hotpoint wf840. What does this mean?

After 6 months of perfect operation, the error code F03 has just started to flash on the display of the washer and it decides to run cold water continuously through and out after stopping its attempt ... more

done

hotpoint first edition 1000?

AC Motor Type 904/1158/07 RPM 800/1500 how to dismatel for inspection,arcing occurring inside windings after an earthing wire broke, i beleive it caused short as motor does not power up but is free t ... more

done

OVERLOADED MY HOTPOINT AQUARIUS NOW THE DOOR WONT OPEN?

OOPS DID IT NOW I PUT IN A DUVET (STUPID ME) AND NOW MY DOOR WONT OPEN PLEASE HELP ME B4 MY HUBBY DIVORCES ME IT IS AN HOTPOINT AQUATIUS 1200 DELUXE WM31

done

How can i fix my Washing machine, Hotpoint, Aquarius 1100?

Stopped working while washing, it has left water in drum, i have taken clothes out but As soon as i turn it on it trips the swith in the fuse board. There does not apear to be any leaking water.

done

HOTPOINT TC71 CONDENSER DRYER BLOWING COLD?

WOULD THE FAULT BE MORE LIKELY THE THERMOSTAT U/S OR THE HEATER ELEMENT U/S ? THE THERMOSTAT HAS A GREEN SPOT REFERENCE MARK ?

done

Hotpoint WMA 32 Changing the door interlock had no effect?

Following replacement of the door interlock the fault remained. The machine attempts to start its cycle but then the door open light flashes and so does any other LED lit; machine fails to start any ... more

done

No heat anymore on my Hotpoint WD62 Aquarius 1200 Washer Dryer?

Can someone guide me on how to fix my WD62 Washer Dryer, since it now does not provide any heat when drying clothes. I have ordered a new Heating element/Thermistor off Hotpoint for about £20. That ... more

done

Diagram/photo of parts for Hotpoint?

Hi all, Does anyone have a diagram or photos, or a link to a site that does, for a Hotpoint WD73 washer dryer? I'd like to locate the condenser and associated parts, so it would make it easier if I ... more

done

Hotpoint Aquarius WM62?

Have had to have the engineer out to replace the door hinge recently.Door now shuts,but machine won't work at all.Is there a ?sensor in the door? did work when you really pushed on the door, but resor ... more

done

how to fit a washer belt?

i can not get my washer belt to fit, it is a hotpoint aquarius wma 33

done

Nasty buzzing sound when dryer comes on hotpoint wd71 washer dyer?

When my dryer comes on it makes a buzzing sound really loud just after around ten minutes into the cycle. I think it is the motor has any one had the same problem

done

Have the motor brushes gone on my hotpoint wma62p washer?

I have a hotpoint wma62p washing machine 18 months old ,out of warranty, the machine was making a sort of clickin noise all day yesterday only when the drum was turning, now today the machine runs th ... more

done

How can i fix my leaking Bosch Excell?

I have a Bosch Excell Dishwasher( Rubbish compared to our old Hotpoint). Its leaking water and i can only remove two plastic mouldings, before i come to a dead end .I don't want to force anything? Co ... more

done

oven hotpoint?

glass for light inside oven

done

how dofix my hotpoint aquarious wm63p?

change the main bearings

done

hotpoint ultima 1200 e14?

does anyone know what error e14 means on a hotpoint ultima 1200 please

done