GG asked ... Fix food processor motor?    |    T asked ... How do I turn the delay off on Electrolux DX302 dishwasher?    |    Helen asked ... How can I mend my Kenwood Gourmet FP505?    |    Roy Turner asked ... Kohlangaz Gosford HE fire?    |    Peter asked ... How can I mend a Powerwasher PRO PRO1800PWE?    |    Click here to ask your question

i have a logik lcxw30nn6 television?

you press the remote it comes on for about 3 seconds then goe,s blank green on light stays on the screen looks dark on one side when its on for the 3 seconds
kevin, January 2008
Just dump it and buy a new tv. I also made the mistake of buying a logik having been lied to by an assistant at currys who told me they were a good tv well known in the U.S not so much over here. 3 repairs later I finally snapped and binned it. I'll never buy anything at Currys again so long as I live.

Neil F., October 2012
my lcxw30nn6 screen comes on blue then goes black , any ideas (do these TVs have a projector lamp ?)

Mick, November 2010
I too have a similar problem, after a few seconds the screen turns like a checker board with tecnicoloured vertical stripes - any ideas?

Lee, November 2008
I think you will find its the inverter gone. What happens is one of the 8 transformers goes bad, the TV starts up, however the inverter control chip senses something is not right and shuts it down. If you strip the TV, and measure the resistance of the transformers, it should be apparent which is faulty. I bought a replacement transformer for £15 but this needed soldering to fit. You can buy a reworked inverter for about £65. There is a website devoted to this type of fault !. P.S. what do computer specialists know about fixing TV's ?.

Ken

Ken, July 2008
Hey,

Iv'e got the same problem with my 27inch logik. I was informed by a computer specialist that the software needs resetting, which can be done by holding down certain buttons whilst the power is on stanby. I have had no luck so far because I do not know what the combination of buttins are. If this isn't the problem then apparently it is because the processor has gone?

Simbo, February 2008
Hey,

Iv'e got the same problem with my 27inch logik. I was informed by a computer specialist that the software needs resetting, which can be done by holding down certain buttons whilst the power is on stanby. I have had no luck so far because I do not know what the combination of buttins are. If this isn't the problem then apparently it is because the processor has gone?

Simbo, February 2008
link Click here to see other fixes for Logik.