My washing machine starts to fill with water at the start of the wash,Then after about two minutes skips to the end of the cycle,If I put it onto the spin cycle it will empty the water but not spin.Can you help

pete dolbear, February 2008

replace the pcb board

rock, March 2013

please email technical@servisuk.co.uk

servis, March 2008

Check out the carbon brushes in the motor. Theyre graphite blocks which transfer mains power to the copper segments of the motor - located at the other end of the motor from the drive pulley. Theyre probably worn down. They're quite cheap parts and easy to replace - the holders are plastic or bakelite and are generally held in with screws or plastic clips. Also, look at the copper segments they run on to check for burning or pitting. If the segments are burnt or damaged you need a replacement motor or a replacement armature (motor part) if you can source one. Occasionally may be a fault in the motor drive circuit board - in which case replacement of board only real option.
Check out my site for info: www.2ndwave.co.uk/manual.html

dan, February 2008

yeah ur pcb is ko needs to replace it

airkool@hotmail.co.uk, February 2008