Pam asked ... Do I need to open the housing to dry the motor?    |    James asked ... Remove enterprise enrolment from an Asus Chromebook C523N?    |    tom schwartz asked ... Bosch maxx 6?    |    Noman asked ... Reverse light switch?    |    Suzie asked ... Stuck Feed dog?    |    Click here to ask your question

triton topaz t100i, no water coming through at all?

HI,
my triton topaz t100i decieded to cut out mid shower (just as i put shampoo on my hair)

the powers ok but there is a light on showing that there is low pressure.

my water pressure is fine throughout the rest of the house,

please help, its not easy washing waist length hair in a small sink =(
Skaedi, February 2008
I had same problem. Low pressure switch Loose on circuit board.(faulty manufacture in my opinion-poor quality soldering) Needs careful electronics engineer to re-solder.

jim, January 2011
Hi,
Mine has done the same thing just this morning.Grrrrr shampoo head.
Bid you get it fixed?

bob, December 2008
will try that, thanks for your help =)

skaedi, February 2008
check your filter in mains pipe to shower.
it's located where the pipe joins the shower unit it may be blocked.

hi-spec plumbing & heating, February 2008
i dont know the actual pressure reading, but if i turn my taps full on the water comes out so fast that it splashes out of the sink, and i dont mean little splashes, it goes everywhere

skaedi, February 2008
what is the mains pressure reding then if you say it's ok?

hi-spec plumbing & heating., February 2008
link Click here to see other fixes for Triton.