Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

How can i fix my Indesi WIA121 washing machine?

I ordered a new heater element as the washing machine wasnt heating the water. After replaceing the element and starting a wash. water began poring out of the new element. The only way i could see to removing the old one was to release the middle nut and the cylinder which pushes into the hole and wiggle and pull and it cam out.
I fitted the new one in reverse.

Is this the correct way
Laurie Hamilton, February 2008
Yes this was easy to fit and cured the problem, many thanks for your service

Laurie, March 2008
sounds as is the rubber seal - oval item which surrounds the element isnt pushed far enough in. theres a channel which runs round the edge. this channel has to be pushed into the metal backplate to form a proper seal.
Check out my site for info: www.2ndwave.co.uk/manual.html

dan, February 2008