i done a normal load this morning with no problems. the washing machine started up as normal. it filled up with water then 5 mintues later i noticed it had swiched off and wont turn back on again! it had a funny smell coming from it like a strong cleaning smell.... i have tried changing the plug over to another socket but still wont switch on! any suggestions on why this might of happened?

carrie-ann, March 2008

is there still a transit bar to remove before instalation and where is it now. easi logic 1300 series

dave, March 2008

Sounds like a motor problem - somethings burnt out. Power off, remove back cover and check out the carbon brushes in the motor. Theyre graphite blocks which transfer mains power to the copper segments of the motor - located at the other end of the motor from the drive pulley. Theyre probably worn down. They're quite cheap parts and easy to replace - the holders are plastic or bakelite and are generally held in with screws or plastic clips. Also, look at the copper segments they run on to check for burning or pitting. If the segments are burnt or damaged you need a replacement motor or a replacement armature (motor part) if you can source one. Occasionally may be a fault in the motor drive circuit board - in which case replacement of board only real option.
Check out my site for info: www.2ndwave.co.uk/manual.html

dan, March 2008