Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

hotpoint wma?

do i need to remove motor to change brushes
tye, March 2008
NO THAY ARE ON THE SIDES OF THE MOTOR IF THAY ARE THE SAME AS A WM25 HOTPOINT WASHER THAY WILL REQUIRE A SCREW DRIVER TO PUSH IN THE LUGS TO PULL THEM OUT THAY ONLY COST £13 A SET TOO MAKE SURE YOU UNPLUG IT FROM THE ELECTRICITY SOCKET FIRST, IT WILL TAKE YOU NO LONGER THAN 7 MINS TO DO THIS .

TOP TIP : IF YOUR WASHER IS CLICKING ON A SPIN CYCLE ITS THE MOTOR BUSHES TRUST ME I KNOW AFTER FIXING OURS WITH NO PARTS AVALIBLE IN NEW ZEALAND FOR OUR WASHER MAKE ONLY PLACE I CAN GET THEM IS THE UK BEING AN EXPAT

RICHARD DOWNS, March 2008
You dont really need to but it makes the job a lot easier. Couple of bolts and a connector is all it takes.
Check out my site for info: www.2ndwave.co.uk/manual.html

dan, March 2008
link Click here to see other fixes for Hotpoint.