What does error code E01 mean for GE front load washer WCVH6260?

The clothes are very wet at the end of the cycle, the washer does not seem to be fully spinning the clothes.

John, March 2008

How is much is a new control panel?

Eric, January 2013

Hi. I'm not a technician, but I had the same issue with mine and was able to fix it. According to the technical papers inside the washer (under the hood), there is no error 1. However, when you enter the service mode initially, it dispays t1 one. Perhaps you are seeing this. Look for this paper, you will need it.

In my case turning the knob to t2 yeilded an error code 70 (stuck key). This is the same code the technician (from Mr. Appliance in Spring, TX) quoted me $460 to fix. He said I needed a new control board. BTW, the boards are ~150 on the net.

I reset the code, and reseated all the connections on the board. Turned it off for a bit and it was fixed.

John, April 2008

E01 - indicates a fault in the motor drive control board. Replacement reqd.
Check out my site for info: www.2ndwave.co.uk/manual.html

washerman, March 2008