hi, i have a two yr old WF640 and the washer when turning quick in the cycle (before spin ) pushes the water back out the drum inlet under the soap draw and floods the room!, no fault codes showing, appreciate any ideas..

sparkie400, April 2008

mine did this last year ...funnily enough it was two years ol too....but i phoned an engineer who kindly advised me to try raising the front of the machine and/or lower the water pressure that feeds the machine under your sink(normally)this worked a treat!!!

nerak, July 2008

sparkie 400

Is the hose from the soap dispenser to the outer drum damaged at all? You may need to remove it from the soap dispenser and/or drum to fully inspect it. If it is holed the pressure exerted by the forces in the drum before the spin cycle when the drum still has not emptied prior to spinning will cause water to gush through the hole hence your floods.

email me on andyparkin58@hotmail.com if this works/or it does not and you require further assistance.

Andrew P., April 2008