Mike asked ... Bosch WTA74200GB Vented Dryer?    |    Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Click here to ask your question

Renault Megane 1998 Immobiliser Problem?

I lost the immobiliser code but managed to get the code from the dealer and programmed it in and the car starts ok but I can't get the fob to work. Can anyone tell mehow to program the fob to the coded immobiliser?? Thanks
kennymcd, May 2008
i have immobiliser problem, went to renault agent and they told me that they are not allowed to give me the code and i have to take it into there workshop. so frustrating.

barry smith, February 2011
I found an helpfull link to some imobiliser problems as follows http://renaulthelp.110mb.com/#WillItWork
hope this is of some help to anyone concerned

RPB, March 2009
key remote not responding

joe foya, November 2008
this process is fine for disarming the immobilsier but the main issue for me is having to do it every time I want to start the car I found all the problems to be cause because the circut board was fried because of water leakage from the antenna assembly which I am rebuilsing and sealing as I type a friend and I may make a new circut board which bypasses the system making the central locks still work and do away with the immobiliser i will keep people posted!

Jordan the mechanic, September 2008
It depends what sort of key you have. With my Renault Megane 1997, you can't reprogramme the key - it has to be done in the factory. I have to go to a Reanult Dealer with proof of who I am and that I own the car, then they order a key in. It takes a few weeks to arrive and costs about £80-90.

Dan, May 2008
when you have entered the code , you need to turn the ignition of then press and hold the central locking button till you hear the door locks make a noise then you need to point the plip key at the receiver in the roof and press the plip 3 times ,also its a little tricky , if you have two plips you need to do this on both plips before the red led goes out on the dash ,if you only got one plip to code in just press annd hold the central button again and start all over , if the door locks dont make a noise , you need to start from putting the code in again.

mark, May 2008
link Click here to see other fixes for Renault.