Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

wheres the filter located?

i have remove the panel and theres no cap or any thing? where is it located because the water wont drain. i have check the waste pipe but that is in order what esle could it be?
re:wd63 washer dryer hotpoint aquarius
malcolm jameson, May 2008
the filter is located in the sump hose at the rear of the drum, you have to remove the rear panel and then release a plastic hose clamp to get to it. Have a shallow bowl ready...

Aldrin, October 2008
the filter is situated behind the FRONT panel at the bottom of machine,small screwdriver removes panel,in bottom right hand corner is a black cover that screws open to reveal filter,a little water will trickle out,this is quite normal.

Barry, June 2008
Filter locations
There are 3 possible places to look as each machine is made differently -
1 if machine has a square flap fitted on the front filter maybe located behind this. (no luck try next one)
2 could be located behind the front lower kick panel (remove panel to see). (no luck its definitely in the last one)
3 located inside the sump hose this is the hose that is attached to the bottom of the outer drum

wirecutterman, June 2008
link Click here to see other fixes for Hotpoint Aquarius.