home Fix label Bathroom Appliances label_important Baths and Showers category Mira

How can I reset my Mira Advance shower?

I need to reset the above shower, we have a low water supply
and the shower comes on then cuts out. Makes a loud bleeping sound both water supply light and reset button is flashing. Tried turning off and on again but same thing happens?

Alison Tomblin, June 2008

home Fix label Bathroom Appliances label_important Baths and Showers category Miradone

What do I have to do to reset Mira shower the 2 red lights are on

JUBILEE PLACE, November 2018

My power button is flashing and the shower keesd turning it self off and on

sam, December 2014

this shower has a built in temperature sensor its a safety feature which will cut the shower off if it believes it is too hot follow the reset instructions in the guide basically have the water at its lowest temperature to start with and gradually raise it up you can find all you need to know here
http://help.tradingdepot.co.uk/wp-content/uploads/2013/09/mira-advance-9kw-user.pdf

andy, February 2014

how do i set mira advance

staffiesam, February 2013

Where is Christine answer???????????????

Ade, March 2011

Any other suggestions - was it the high power you pressed - is there a reset button anywhere on the Advanced model

Martin, June 2010

I need to reset the above shower, It wil run when it is cold but resets when I turn the temperature up! Any IDEAS?

Keith, June 2010

thanks for the answer christine, worked perfectly
Gino XXX

Gino, November 2009

Ity worked for me too thx

christine x, May 2009

i had same problem. but wait about 5 or 10 minutes, hold power button in and pull main power cord on. It worked for me. ( i know it sounds back to front but it worked). Good luck, Andy

Andy, June 2008

will do if you have a low water supply.

hi-spec plumbing & heating, June 2008

link Click here to see other fixes for Mira.