After running an update by pressing the red button in user information i have no picture for any channel. It says that they are there and even tells you what the programme is all about on the epg extented mode. Anyone any ideas how i can fix this?
The problem started after i noticed my film channels were receiving no signal and ran a power scan. After that i ran an auto scan and still had no luck.

I posted a question earlier but put the wrong info in about the model so ignore the question with the model cvb.

Colin, August 2008

mi eurovox box has 182 channels on it but onli 5 of them wrk hw do i get the rest on help plz

marcus, September 2010

my remote is not working can anyone help?

zizu, February 2010

got codes how do i put them in

donnie, November 2008

well colin, the problem is in your provider cable and not in the eurovox, has to be broken lead comming from it , is the little silver plug on the end of the cable,that you put into the tv , tight" on the cable , or is it moveing a little, can you try the box nextdoor, just to test the cable, ?if it bad on the tv and your only getting one one channell it has to be a problem with the tv incomming cable,

mick, August 2008

I tried the cable in the tv and only got itv channel and no other and that was a bad picture. I have done nothing to my box apart from try a scan. I have even tried connecting my box direct from the cable box on the wall.

Colin, August 2008

can you check the provider cable commimg into your home just on a tv , to see if your getting the signal ok , just plug it into the tv to test it.

mick, August 2008

everything is right at that end then , and are you you getting normal channells on the cable thats comming in , just on the tv,not useing the box, and was the box updateing itself/ or did you have to put the codes in.

mick, August 2008

Thanks for your time mick, the cable is plugged in at the top left in the rf in.

Colin, August 2008

ok colin,had to try that , tell me were you have the cable pluged into at the back of the eurovox,

MICK, August 2008

My list of programmes are there and i have also tried to change the symbol rate from 6952 to 6887 while doing a power scan which picked up one only channel. I then run a power scan using the original symbol rate number of 6952 and i'm now back to square one with all my channels there but no signal.

Colin, August 2008

you might have changed the symbol rate, go back into (user installation)press the power scann button, a new window will open up" showing 100mzh flashing" under that is 870mzh, and under that is the symbol rate , it might show 6887, or 6952, so if its showing 6887 now change it to 6952 with your remote" or the other way around, and press(ok) to scann, if the symbol rate is right for your tv provider , you will see a list of channells comming up on your tv , this scann takes 20min, ill check back here

mick, August 2008