Have not used CH in few months tried to use today and would not work. Have hot water and pilot light comes on for this but no noise from boiler for CH. Have enough water pressure, led light is green and not flashing.
Can not figure out from manual what possible problem may be. Any ideas??

help claire, September 2008

the pump may be stuck, try a gentle tap on the caseing to free it. You should feel some vibration if it is running properly.

Regards bobby1551

bobby1551, September 2008

Hi Claire

If this is an idea and you have tried it sorry, its the only thing I can think of. Have you addjusted the timer behind the door on the fromt of the boiler? The round thing with spiky things; make sure that the CH is set to be on with the timer spiky things (techincal eh?) and then make sure the little slide switch it set for the CH to come on.
Hope this helps

Iain, September 2008

may be silly question have you moved the selector switch from hot water only to both
if you have try moving the switch to the off position and see if the light goes of if it stays on the selector switch is broken and will need replaced
if the switch is ok it sounds like the boiler is not getting the message that heating is required is it an integral timer or external please advise so i can help you further if required

ricky, September 2008