Susan asked ... How can I stop my steam iron spraying water with the steam?    |    alex asked ... Reanult clio 2008?    |    p jackson asked ... Aquatronic 1 plus?    |    simon james templeton asked ... How can I refill the 6-speed automatic transmission fluid 2L?    |    Ali asked ... Replace wires to circuit board correctly?    |    Click here to ask your question

Bobbin Assembly pops out on Singer 360?

The bobbin assembly pops out on my singer 360 whenever it runs. It will not stay in, no bobbin tension, makes a heckuva mess. How can I correct this?
Rhonda, September 2008
Helllo Rhonda,
You have probably got the black plastic bobbin case, make sure the bobbin case is close to the right hand guide with only a small gap for the thread to pass through, if you can waggle the bobbin case about then you need to slacken off the two screws on the right hand side and move the guide over, make sure there are no nicks or rough spots on the bobbin case for the thread to catch and pull it out.
Ken

drivewithken@blueyonder.co.uk, September 2008
link Click here to see other fixes for Singer.