i mopped out the water and the E4 problem went away however when I tried to put on a cycle ,no light appear to show the chosen cycle. Then when I press down hard on the P Key , 13 appears on the little screen .If I close the door a cycle runs , but the dishwasher does not drain. Also sometimes the E4 and water happen again.Any advice would be greatly appreciated .

David, September 2008

Hi David, I think that there is a fault in the pcb display and that some of the digits are missing.It may be P3 but as part of the display is missing it looks like 13.The drain pump may be stuck and this floods the base or it could be that the air break/filler is leaking filling the base.This cuts and aborts the programme before the drain.All the best.

FOXY, September 2008