Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

carb. adjusting tool?

My poulan chain saw runs well but will not idle without
turning the throttle adj. up to the point where the
clutch is always engaged.The idle richness screw
appears to be a special driver that has a spline like
interior.Is there a tool available from Poulan?
This is extremely annoying 280 miles from a service
centre.
keith bennett, October 2008
It's Torx headed screw. The correct size torx driver will do the job. Do NOT try to adjust the screw witha philips screwdriver!

Stephen Brown, October 2008