Hello,

When I start my Diplomat ADP8500 it sounds like it is trying to start the cycle but then after about 30 seconds it just stops. The lights stay on but they don't flash. It is as if there is no fault being indicated. Any advice would be greatly appreciated.

Ian Hodgkinson, October 2008

Hi Foxy.

Thanks for your response.
I tried holding the the start button but it does does as previously mentioned.

Thanks all the same

Ian Hodgkinson, October 2008

Hi Ian, It may be the pcb in the base.I have had this fault and it was the pcb that was faulty.It may be a number of things but it seems the best bet.Have you kept your finger on the start button and reset the programme,sometimes it can lock into the last unfinished prog. All the best.

FOXY, October 2008