GG asked ... Fix food processor motor?    |    T asked ... How do I turn the delay off on Electrolux DX302 dishwasher?    |    Helen asked ... How can I mend my Kenwood Gourmet FP505?    |    Roy Turner asked ... Kohlangaz Gosford HE fire?    |    Peter asked ... How can I mend a Powerwasher PRO PRO1800PWE?    |    Click here to ask your question

how to reset a laserline t101v2 car alarm?

I disconnected my battery and when I connected it again the horn part of the laserline t101v2 will not work. The central locking and the flashing indicators are working and are activated when the alarm goes off, but no sound at all, what have I done?. The car is a mitsubishi pajero 2.8 diesel
mark, October 2008
My fob does not work my van will not start I press the fob nothing turn key and the light out

Palmer, January 2020
my car alarm keeps going off on my daewoo musso 1999. After you turn it off you get a couple of beeps then a few seconds later the alarm goes off again, do you have any solutions to my problem?

susan, July 2012
hi there
it sounds like the siren driver has blown (repaired loads)
contact:
www.vehicle-electronicsdirect.co.uk

macca, February 2010
With the alarm system disarmed, enter the car and close all doors boot bonnet. Turn on the cars ignition, open the drivers door then press the arm/disarm button on the remote handset and look for the following information.
Enabled: The dash fascia LED will flash once followed by a short tone from the siren.
Disabled: The dash fascia LED will flash twice without a alarm siren tone.
Turn off car ignition, close all dors and arm the the usual way.
Hope this helps.

Regards,
Sir Peter Murdoch- Smith

Sir Peter Murdoch-Smith, April 2009
link Click here to see other fixes for Mitsubishi.